Standard Exothermic Welding Tools
Standard Exothermic Welding Tools Exothermic Welding Malaysia, Kuala Lumpur (KL), Selangor Supplier, Manufacturer, Supply, Supplies | Delta Sama Jaya Sdn Bhd

Mold Cleaning Brush

Code : DSSB KTA 006

DSSB Mold Cleaning Brush is a tool consisting of a handle and brush. The brush is usually made from a large number of steel wire, brass or stainless steel depending on application. It uses to clean mold surface.

When cleaning stainless steel it is advisable to use a stainless steel bristle wire brush. Brass bristle brushes are used on softer surfaces or in potentially flammable environments where non-sparking tools are required.

Metal Bar Cleaning Brush

Code : DSSB KTA 003

For cleaning Flat surfaces of metal and Bar before putting into the mold.


Cable Clean Brush

Code : DSSB KTA 007

For cleaning Round conductors , earth rods and other circular object/ product.


Mold Scraper

Code : DSSB KTA 008-011

Scraper Code No.:DSSB KTA  008  009  010  011
For Weld Metal Powder (g) 15 - 32 45 - 90 115 - 250 above 300

Use for removing Slag from mold surfaces just after completing the exothermic welding process.

Flint Ignitor

Flint ignitor is used to ignite the ''Starting Powder/Material'' to start the exothermic welding process inside the mold.
Flint ignitor has to be place a few inches away from the mouth of the mold so that the spark can ignite the ''Starting Powder'' easily.

There comes in small size and handy. The mechanical flint ignitors gives long service cycles.
They produce a big sparks for ease of igniting the starting powder. The worn out flints can be replaced with new flints with minimal cost.

Please leave your enquiry here, we will reply as soon as possible.

*only support gif, jpeg, jpg, png, pdf
Switch To Desktop Version